Cisco 11500 Series Hardware Installation Manual page 131

Appendix C Connecting a Modem to the CSS
Make sure that the settings on the remote console match the CSS default settings
specified in
Table C-1
Parameters
Baud
Data Bits
Parity
Stop Bits
Terminal Type
Flow Control
When you remotely log in to the CSS through a modem, make sure that you log
Note
out before disconnecting from the session. Use the idle timeout minutes
command to set the maximum amount of time that the console session can be idle
on the CSS before the CSS logs it out. By default, the timeout is disabled.
78-17231-01
Table C-1.
CSS Console Port Default Settings
Default Settings
9600
8
None
1
VT100/ANSI
None
Cisco 11500 Series Content Services Switch Hardware Installation Guide
Cabling a Modem to the CSS
C-3