Printhead Replacement - Intermec EasyCoder 501 XP Installation & Operation Manual

Printhead Replacement,

3
Remove the paper and transfer ribbon, if any.
5
Snap-lock
Disconnect the hooked printhead bracket fingers
from shaft and pull out the printhead as far as
the cables allow.
Intermec EasyCoder 501 XP – Installation & Operation Ed. 3
cont'd.
4
Pull the printhead bracket away from the
6
Disconnect the two cables from the printhead.
Note the snap-lock on the white connector. Pull
at the connectors – not the cables!
Chapter 12
magnet in the lift arm
Maintenance
91