CAMSHAFT AND CYLINDER HEAD
4 - 21
3.Measure:
Cylinder head warpage
●
Out of specification → Resurface.
Cylinder head warpage:
Less than 0.05 mm (0.002 in)
*****************************************************
Measurement and resurfacing steps:
●
Place a straightedge and a feeler gauge
across the cylinder head.
●
Use a feeler gauge to measure the warpage.
●
If the warpage is out of specification, resur-
face the cylinder head.
●
Place a 400 ~ 600 grit wet sandpaper on the
surface plate, and resurface the head using
a figure-eight sanding pattern.
NOTE:
To ensure an even surface rotate the cylinder
head several times.
*****************************************************
INSTALLING THE CAMSHAFT AND
CYLINDER HEAD
1.Install:
Cylinder head
●
Bolts (M9 : 1 ~ 6)
●
38 Nm (3.8 m • kg, 27 ft • lb)
Bolt (M6 : 7)
10 Nm (1.0 m • kg, 7.2 ft • lb)
●
NOTE:
Tighten the bolts in the proper sequence.
●
Follow the numerical order shown in the illus-
●
tration. Tighten the bolts in two stages.
ENG