FRONT CONSTANT VELOCITY JOINTS AND
DIFFERENTIAL GEAR
2.Install:
Dust boots 1
●
Boot bands 2, 3
●
*****************************************************
Installation steps:
●
Apply molybdenum disulfide grease into the
dust boots.
Molybdenum disulfide grease:
40 g (1.4 oz) per dust boot
●
Install the dust boots.
●
Install the dust boot bands.
NOTE:
The new boot bands may differ from the orig-
●
inal ones.
The dust boots should be fastened with the
●
boot bands 3 at the grooves in the joint
shaft.
*****************************************************
3.Check:
Free play (thrust movement)
●
Excessive play → Replace the joint assem-
bly.
ASSEMBLING THE DIFFERENTIAL GEAR
1.Measure:
Gear lash
●
Refer to "MEASURING AND ADJUSTING
THE DIFFERENTIAL GEAR LASH".
2.Install:
Gear motor
●
7 - 12
DRIV
New