Changing The Coolant - Yamaha YFM660FP Service Manual

CHECKING THE COOLANT LEVEL/

CHANGING THE COOLANT

3 - 32
3.Check:
Coolant level
●
The coolant level should be between the
minimum level mark a and maximum level
mark b.
Below the minimum level mark → Add the
recommended coolant to the proper level.
CAUTION:
Adding water instead of coolant lowers
●
the antifreeze content of the coolant. If
water is used instead of coolant, check
and if necessary, correct the antifreeze
concentration of the coolant.
Use only distilled water. However, soft
●
water may be used if distilled water is not
available.
4.Start the engine, warm it up for several min-
utes, and then turn it off.
5.Check:
Coolant level
●
NOTE:
Before checking the coolant level, wait a few
minutes until the coolant has settled.
6.Install:
Fuel tank side panel (left)
●
Seat
●
Refer to "SEAT, CARRIERS, FENDERS
AND FUEL TANK".
CHANGING THE COOLANT
1.Remove:
Seat
●
Fuel tank side panel (left)
●
Engine side cover
●
Front carrier
●
Front fender panel
●
Coolant reservoir cover
●
Refer to "SEAT, CARPIERS, FENDERS
AND FUEL TANK".
Left footrest board
●
Refer to "FOOTREST BOARDS".
CHK
ADJ