Securing Boat To Trailer; Wheel Bearings - WARRIOR BOATS Boats User Manual

Securing Boat To Trailer

Use adequate tiedowns for load and trip conditions.







Wheel Bearings

The Accu-Lube system manufactured by Quality Trailer
Products is a patented design, which affords the privilege of
lubricating both the inner and outer bearing without removing
the hub/drum from its normal operating setting. Usage of the
Accu-Lube system will not eliminate the need for general
maintenance and inspection of the hub/drum assembly.
Recommended maintenance of this system is to insert Lithium
wheel bearing grease through the "Zerk" fitting provided in the
end of the dust cap until it flows freely from the vent hole
located in the rear of the spindle arm. The recommended service
schedule is as follows:



Attach bow to trailer with safety chain or U-bolt. Winch
line should be tight, but do not rely on winch line to
fasten bow to trailer.
Use at least two nylon web tiedowns to secure transom
to trailer.
Add tiedowns on side of boat if load or road conditions
require. Place side tideowns near the stern where most of
the boat's weight is located.
Pad tiedowns where they contact the boat to prevent
damage to the finish.
If boat cover is used, ensure drawstring is drawn tight.
Add ropes if necessary.
Stow any loose gear whether or not you use a boat cover.
After the first 250 miles it is very important to grease the
bearings to exhaust the metal shavings from the bearing
break-in period.
After break-in period, grease bearings every 1,000 miles.
Check tire pressure and brake fluid every 1,000 miles.
CAUTION
8-2