36 Volt Trolling Motor; Wiring - WARRIOR BOATS Boats User Manual

36 Volt Trolling Motor

Wiring:

Red Plug – The red plug is connected to the red wire from the
trolling motor. Insert the wire into the opening marked "+".
Make sure that all terminals are tight. Install plug body onto plug
base.
Black Plug – The black plug is connected to the black wire from
the trolling motor. Insert the wire into the opening marked "12".
For Minnkota Vantage, insert the yellow 12 volt wire in the same
opening (marked "24") as the black jumper wire. Make sure that
all terminals are tight. Install plug body onto plug base.
Operation:
Both the Bow Panel and the Power Charger Panel (at stern) are
wired for 12, 24, or 36 volts.
Bow Panel – To operate the trolling motor, insert the red plug
into the receptacle on the right. And then insert the black plug
into the receptacle on the left. This is the only way the system
will work. If the plugs are reversed, the trolling motor will not
operate. The complete circuit is protected with 50 amp circuit
breakers. Make sure that Power Charge Jumper Wire is not
installed before connecting trolling motor on the bow.
Power Charge Panel (at stern) – To operate the trolling motor,
insert the red plug into the receptacle marked "Troll". Then
insert the black plug into the receptacle marked "Start". If plugs
are reversed, the trolling motor will not operate. Make sure that
bow mount trolling motor is not plugged in before
connecting trolling motor on transom.
Power Charge Panel – the Power Charge Panel will operate as
normal. With this system, the cranking battery and all three
trolling motor batteries can be charged by running the main
engine. Insert the Power Charge Jumper wire, and run the main
engine. Make sure that bow mount trolling motor is
disconnected before installing Power Charge Jumper Wire.
5-10