Trolling Motor Circuit Protection; Tilt Harness - WARRIOR BOATS Boats User Manual

Battery Energy Gauge – Bow Panel
Depress "Test" – monitor will display battery status
Battery Energy Gauge – Stern Panel (Backtroller Models)
Depress "Test" – monitor will display battery status

Trolling Motor Circuit Protection

The two trolling motor wire harnesses (one from the bow, one
from the stern) are protected with inline circuit breakers. They
are located on the positive leads of the trolling motor wiring
harness about 8"
from the battery terminal end. The circuit breakers are the
automatic reset type. If tripped they automatically reset. They are
50 amp circuit breakers.
The Power Charge Panel also has a 50 amp circuit breaker. It is
on the positive wire from the "start" port on the Power Charge
Panel. The circuit breaker is located about 8" from the battery
terminal end.

Tilt Harness

Attach tilt harness at the engine. Purple wire is hot lead; green
wire is down mode and blue wire is up mode. These colors
should correspond to pre-existing wires if not, further testing
with a continuity tester is necessary.
5-6