CyberData RAL 9003 Operation Manual page 3

Revision Information
Revision 930468D, which corresponds to firmware version 6.5.3, was released on August 22, 2014,
and has the following changes:
•
•
•
•
•
•
•
•
•
•
•
•
•
Operations Guide
Add the following Note at the end of
"You can change the Speaker Volume without rebooting the device. You must click on the Save
button and then the Reboot button for other changes to take
Adds the VLAN ID (0-4095)
Adds the VLAN Priority (0-7)
Updates Step 3, "You must click on the Save button and then the Reboot button for the changes
to take effect." in Section 2.3.4, "Configure the Network
Adds the Disable rport discovery
Updates the Beep Before Page
following:
"When selected, the device will play a beep before a page is sent on SIP pages (works for both
buffered and live pages)."
Updates the Re-registration Interval (in seconds)
Configuration Parameters"
"The SIP Registration lease time in
Add the following text at the beginning of
"The Multicast Configuration page allows the device to join up to ten paging zones for receiving
ulaw/alaw encoded RTP audio
"A paging zone can consist of one or many CyberData multicast group-enabled products. There
is no limit to how many speakers can be in a given paging zone. Each multicast group is defined
by a multicast address and port
"Each multicast group is assigned a priority, allowing simultaneously arriving pages to be
serviced based on importance. Multicast groups are compatible with IGMP through version 3.
The device supports simultaneous SIP and
Add the following text at the beginning of
Parameters":
"Autoprovisioning can be used to configure your device automatically on boot, after a periodic
delay, after sitting idle for a period of time, or at a specified
"The autoprovisioning file contains the board configuration in xml format. Autoprovisioned
values in this file will override values stored in on-board
"The autoprovisioning file can be hosted with a tftp or a web server and by default is named
according to the MAC address of the device (for example: 0020f7350058.config). The
autoprovisioning filename can also be
"The device does not have a real time clock but can sync with a network time server on
Adds the NTP Server setting to
Adds the Posix Timezone String
Parameters".
Adds the Set Time with External NTP Server on boot
"Autoprovisioning Configuration
Adds the Periodically update with time server
Configuration Parameters".
Table 2-6, "Device Configuration
setting to Table 2-7, "Network Configuration
setting to Table 2-7, "Network Configuration
setting to Table 2-8, "SIP Configuration
setting in Table 2-8, "SIP Configuration Parameters"
setting description in
to the following:
seconds."
Section 2.3.7, "Configure the Multicast
streams."
number."
Multicast."
Section 2.3.11, "Configure the Autoprovisioning
specified."
Table 2-19, "Autoprovisioning Configuration
setting to Table 2-19, "Autoprovisioning Configuration
Parameters".
setting to
930468D
Parameters":
effect."
Parameters".
Parameters".
Parameters".
Parameters".
Table 2-8, "SIP
time."
memory."
Parameters".
on boot button to Table 2-19,
Table 2-19, "Autoprovisioning
CyberData Corporation
to the
Parameters":
boot."