Checking Power Trim And Tilt System - Yamaha E115A Owner's Manual

w
EMU01690
CHECKING POWER TRIM AND TILT
SYSTEM
w
8 Never get under the lower unit while it
is tilted, even when the tilt-support
lever is locked. Severe injury could
occur if the outboard accidentally falls.
8 Make sure no one is under the out-
board before performing this test.
1) Check the power trim and tilt unit for
2) Operate each of the power trim and tilt
q
3) Tilt up the motor and check that the tilt
411046
4) Use the tilt support lever 3 to lock the
e
5) Check that the tilt rod and trim rods are
6) Activate the tilt-down switch until the
411044
7) Activate the trim-up switch until the tilt
8) Operate the motor to tilt down. Check
NOTE:
If any operation is abnormal, consult a
Yamaha dealer.
411045
any sign of oil leaks.
switches on remote control and engine
bottom cowling (if equipped) to check
that all switches work.
rod 1 and trim rods 2 are pushed out
completely.
motor in the UP position. Operate the
tilt down switch briefly so the motor is
supported the tilt support lever.
free of corrosion or other flaws.
trim rods have gone completely into the
cylinders.
rod is fully extended. Unlock the tilt
support lever.
that the tilt rod and trim rods operate
smoothly.
E
4-22