INSP
ADJ
CONTROL SYSTEM
Shift cable inspection and adjustment
1. Check:
Reverse gate stopper lever position
Incorrect → Adjust.
Checking steps:
Set the shift lever to the reverse posi-
tion.
Check to make sure the reverse gate 1
contacts the stopper 2 on the bracket
and the lever 3 contacts the reverse
gate.
2. Adjust:
Shift cable joint
Adjustment steps:
Loosen the locknut 1.
Disconnect the cable joint 2 from the
ball joint 3.
Turn the cable joint to align it with the
ball joint.
Turn in
Turn out
Turn out the cable joint nine times
from the aligned position.
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint and tighten the
locknut.
Locknut:
3 Nm (0.3 m • kg, 2.2 ft • lb)
3-6
Shortens.
Lengthens.
E