Yamaha WaveRunner XL1200Ltd Service Manual page 32

INSP
ADJ
CONTROL SYSTEM
2. Adjust:
QSTS cable
Adjustment steps:
Set the control grip in the neutral posi-
tion.
Set the jet nozzle in the center posi-
tion.
Remove the nut 1 and pivot pin 2.
Loosen the locknut 3.
Turn the cable joint 4 for adjusting.
Turn in
Turn out
WARNING
The cable joint must be screwed in more
than 8 mm (0.31 in).
Connect the cable joint 4 and pivot
pin 2 and tighten the nut 1.
Nut:
4 Nm (0.4 m • kg, 2.9 ft • lb)
Tighten the locknut 3.
Locknut:
4 Nm (0.4 m • kg, 2.9 ft • lb)
NOTE:
If correct adjustment by using the cable
joint at the wheel end is not obtained,
adjust the cable joint on the trim nozzle end.
3-5
Length b is increased.
Length a is increased.
E