Speed Sensor - Yamaha WaveRunner XL1200Ltd Service Manual

– +
ELEC
INDICATION SYSTEM

Speed sensor

1. Check:
Speed sensor output voltage and
pulses
Out of specification → Replace.
Speed sensor output voltage
(dependant on the paddle wheel
position):
Less than 400 mV/11.6 - 12 V
Output pulse:
2 pulses/one-full turn
Checking steps:
Apply DC 12 voltage to the white
three-pin connector (between the red/
white and black leads).
Rotate the paddle wheel by hand and
measure the voltage between the
black and yellow leads.
NOTE:
As the paddle wheel is rotated, a square-
wave voltage signal a is produced.
Two pulses occur every time the pad-
dle wheel makes one-full turn.
7-44
E