Fuel System - Yamaha WaveRunner XL1200Ltd Service Manual

INSP
ADJ
CONTROL SYSTEM/FUEL SYSTEM
3. Adjust:
YPVS cables 1 and 2
Adjustment steps:
Loosen locknuts 1 and 2.
Turn in the adjuster 3 and 4 until
there is slack in the cable.
Align the hole a in the pulley with the
hole in the cylinder.
Insert a 4-mm-diameter pin through
the holes in the pulley and cylinder.
Turn the adjuster 3 and 4 in or out
until the specified slack is obtained.
Turn in
Turn out
Finger tighten the locknut 1 and 2.
Remove the pin.
Start and stop the engine.
Recheck the hole alignment.
If the hole alignment is correctly,
tighten the locknut.
If the hole alignment is incorrect,
repeat the above steps.

FUEL SYSTEM

WARNING
Stop the engine, set the fuel cock to
"OFF" and loosen the fuel filler cap before
servicing the fuel system.
When removing fuel system parts, wrap
them in a cloth and take care that no fuel
spills into the engine compartment.
3-8
Slack is increased.
Slack is decreased.
E