Access Control - Planex BLW–HPMM–U User Manual

2.2 Access Control List
The Access Control function allows administrators to restrict the level of
Internet access. When the Policy function is enabled, the IP address in the
list will be restricted or the IP address/Port in the list will be prevent from
using certain Internet services. The default value is that every user can
access the Internet.
Policy You can scroll down the policy list to choose if you want to log
the events. If you choose to log the event, all the blocked events will be
recorded.
Priority Click the Enable check box, and rank the access priorities
(0-high~8-low).
Direction/IP Choose the direction is from the outside or inside, and
enter the IP address/segment or its subnet mask.
Type Choose the port type which corresponding with the previous port
number.
Port Enter the port number to or from which you want to block.
Day Set the days in a week to perform Access Control.
Time Set a period of time to perform Access Control.
Enable Click the check box to enable the settings.
Apply Click this button to save the setting and restart the router.
Reset If there is anything wrong with the settings, you can click
Reset to configure the page again.
Chapter 3 Advanced Setup & Configuration
3
71