Planex BLW–HPMM–U User Manual page 54

Unnumbered Network Mask Please enter the Network Mask
2
provided by the ISP. Enter the unnumbered network mask, only when
you choose unnumbered LAN type.
Destination Network 1~4 Enter this column, only when you choose
NAPT LAN type.
None: Choose this to disable the function.
IP Range Please enter the range of IP addresses provided by your ISP.
Domain You can set a domain name as the transmission rule. For
example, entering planex.com.tw in this column, it means the packets
which use planex.com.tw as destination will be delivered through this
segment.
TCP Port You can set a TCP Port or use range of TCP ports.
UDP Port You can set a UDP Port or use range of UDP ports.
Default You can appoint PPPoE 0 or PPPoE 1 to be the default dial-up
connection.
Dial-On-Demand/Silent Timeout You may disconnect the connection
when there is no activity for a period of time and set the Silent Timeout
in the next field. Silent Timeout means a period of idle time before you
go offline. Enter a maximum period of time (seconds) to define the
maximum idle time. If the silent time is above the defined maximum idle
time, it will go offline immediately. You can set the value to be 0 or Auto
Reconnect to disable this function.
Auto Reconnect/Dial Status If you choose Auto Reconnect, BLW-
HPMM-U Wireless Router will automatically reconnect to your ISP
when you restart the system or the connection is stopped. To enable
Auto Reconnect you must set Silent Timeout to be 0 or leave the
field blank; otherwise there might be a warning message.
Auth Type BLW-HPMM-U supports WPA encryption. You may
choose PAP or CHAP authentication to enhance the security of data
transmission.
46
BLW-HPMM-U