Operating Voltage And Frequency - Coemar Infinity Wash XL Instruction Manual

5.1. Operating voltage and frequency

The projector may operate at voltages of 200, 208, 230 or 240VAC at a frequency of 50 or 60Hz. Coemar presets (barring specific
requests) a voltage of 230v at a frequency of 50Hz.. The preset voltage is indicated on the base of the projector.
Infinity Wash XL will automatically adjust its operation to suit a frequency of 50Hz or 60Hz.
5.2. Altering the operating voltage
If the factory preset operating voltage do not correspond to those in use in your country of operation, you may alter the settings as descri-
bed in the following paragraphs.
5. Powering up
(Reserved for technical personnel only)
Incorrect selection of operating voltage will seriously compromise the
functioning of the projector and will immediately void the warranty.
ATTENTION!!
1. Loosen the screws "A" on the cover of the base of the unit, as shown in
the diagram below, using an appropriate screwdriver, thereby removing
the cover completely and allowing access to the internal components of
the base of the Infinity Wash XL.
2. Locate the main selector in the base of the unit.
3. Select a voltage from amongst 200, 208, 230 or 240V by moving the
selector to the correct voltage.
4. When you have made changes, note these on the outside of the
Infinity Wash XL.
5. Replace and fasten all the housings as per their original positions.
9
English