Table of Contents
Advertisement
English
MBER
:
COMMUNICATION Error
This message indicates that the motherboard within the unit is not communicating properly with the control
source. Check the connectors located on both boards.
OPER
:
PAN ENCODER Error
This message indicates that there is a problem with the PAN encoders. Check the sensors on the encoder wheel
located near the pan movement motor, as well as the relevant cabling.
OTER
:
TILT ENCODER Error
This message indicates that there is a problem with the TILT encoder locate on the fixture yoke. Check the sen-
sors on the encoder wheel located near the pan movement motor, as well as the relevant cabling.
EPER
:
EEPROM Error
The EEPROM is either defective or absent; refer to your Coemar service centre for a replacement component.
DTER
:
DATA Error
The initial parameter settings are incorrect or corrupt; the projector has reloaded its factory default settings. Turn
the projector off and on again. Should the error reoccur, refer the unit to your authorised Coemar service cen-
tre to have the EEPROM check and possibly replaced.
ADER
:
DMX addressing Error
The projector is not receiving all DMX channels needed to operate correctly. Check the DMX address indicated
on the display and the channel numbers being outputted from the controller. Note that not all controllers will
output all 512 channels.
S1ER
:
Control circuit error relating to position sensors for 4 motors located upper in the yoke
(EFFECT):
Check for the presence of power to the PCB and the condition of the connectors and cabling between the PCB
and the sensors. Additionally, check motors and/or cogs for any impediments as well as the proper position of
the cabling connectors.
S3ER
:
Control circuit error relating to position sensors for 5 motors (ZOOM):
Check for the presence of power to the PCB and the condition of the connectors and cabling between the PCB
and the sensors. Additionally, check motors and/or cogs for any impediments as well as the proper position of
the cabling connectors.
S4ER
:
Control circuit error relating to position sensors for 4 motors located lower in the yoke
(COLOR WHEEL):
Check for the presence of power to the PCB and the condition of the connectors and cabling between the PCB
and the sensors. Additionally, check motors and/or cogs for any impediments as well as the proper position of
the cabling connectors.
COER
:
Position Error in COLOUR WHEEL
Check the functioning and correct positioning of the magnetic sensor of the colour wheel.
EFER
:
Position Error in EFFECT WHEEL
Check the functioning and correct positioning of the magnetic sensor of the effects wheel.
REER
:
Position Error in EFFECT INDEXING
Check the functioning and correct positioning of the magnetic sensor of the effects indexing.
ZOER
:
Position Error in the ZOOM LENS carriage
Check the functioning and correct positioning of the magnetic sensor of the zoom lens carriage.
ZEER
:
Position Error in the ZOOM EFFECT carriage
Check the functioning and correct positioning of the magnetic sensor of the zoom effect carriage.
LEER
:
Position Error in the ZOOM LENS
Check the functioning and correct positioning of the magnetic sensor of the zoom lens.
ER20 ÷ ER99
:
SYSTEM Error
Turn the unit off and on again. If the error persists, contact your authorised Coemar service centre.
13. Error messages
24
Advertisement
Table of Contents
