Frequently Asked Questions - Coemar Infinity Wash XL Instruction Manual

Question
The projector is completely
immobile.
The projector resets correctly, but
either does not respond, or
responds incorrectly, to DMX
signal.
The lamp turns off intermittently The projector is too hot.

14. Frequently asked questions

Possible cause
Projector not powered up.
The circuit breaker is switched off
The protection fuse is blown
Incorrect signal connection
Incorrect DMX address
Possible solution
Check that the mains power cable is connected
to power.
Set the circuit breaker to ON.
Disconnect the projector and replace the fuse.
Inspect the signal cable, rectify any incorrect
wiring, repair or replace any damaged cables or
connectors.
Check the DMX address.
Let the fixture cool down.
Check that the air vents above the cooling fans
are not obstructed and that the fans are working
correctly.
Ensure that the ambient temperature is below
35 °C.
One of the fans does not work correctly and cau-
ses the overheating of the projector.
25
english