Aligning The Lamp In The Optical Path - Coemar Infinity Wash XL Instruction Manual

English
4. Insert the lamp and rotate clockwise.
The lamp used is manufactured from quartz glass and should be handled with care; always adhere to the instructions supplied in the
lamp' s packaging. Never touch the glass directly, use the tissue provided in the lamp' s packaging. DO NOT USE UNDUE FORCE.
5. Replace the lampholder cover in its original position and refasten the two screws "A" which were previously removed.
Each time you change the lamp, we recommend the following be carried out:
• realign the lamp in the optical path to avoid overheating dichroics and/or effects.
• reset the lamp life counter (as described in section 8.7. Resetting the counter).

9.2. Aligning the lamp in the optical path

Aligning the lamp in the optical system is achieved via the 3 adjusters at the rear of the projector. This procedure should be undertaken
to maximise output, properly align the lamp in the optical system and to avoid the possible overheating of the internal components due
to the incorrect focusing of the beam onto components not intended to be exposed to this.
Alignment procedure
Alignment is effected by the 3 adjusters A, B and C located on the lampholder assembly. The lamp should be on, black-out and dimmer
fully open, and no colours selected. If the lamp is not correctly aligned, a hot-spot will be readily noticeable. Using the 3 adjusters in uni-
son, you will need to bring the hot-spot to the centre of the beam and then flatten the beam to maximum uniformity.
ATTENTION!!
20