Table of Contents
Advertisement
Object
Fragment Threshold
RTS Threshold
Beacon Interval
Preamble Type
IAPP
Protection
Aggregation
Short GI
WLAN Partition
RF Output Power
You can specify the maximum size of packet during the fragmentation
of data to be transmitted. If you set this value too low, it will result in
bad performance.
Default is "2346".
When the packet size is smaller the RTS threshold, the access point
will not use the RTS/CTS mechanism to send this packet.
Default is "2347".
The interval of time that this access point broadcast a beacon. Beacon
is used to synchronize the wireless network. Default is "100".
Preamble type defines the length of CRC block in the frames during
the wireless communication. "Short Preamble" is suitable for high
traffic wireless network. "Long Preamble" can provide more reliable
communication.
Default is "Long Preamble".
IAPP (Inter-Access Point Protocol) enabled is recommendation that
describes an optional extension to IEEE 802.11 that provides wireless
access-point communications among multivendor systems.
Default is "Enabled".
It is recommended to enable the protection mechanism. This
mechanism can decrease the rate of data collision between 802.11b
and 802.11g wireless stations. When the protection mode is enabled,
the throughput of the AP will be a little lower due to many of frame
traffic should be transmitted.
Default is "Disabled".
It is a function where the values of multiple rows are grouped together.
Default is "Enabled"
It is used to set the time that the receiver waits for RF reflections to
settle out before sampling data.
Default is "Enabled"
This feature also called "WLAN isolation" or "Block Relay". If this is
enabled, wireless clients cannot exchange data through the
WNRT-320GS.
Default is "Disabled".
Users can adjust the wireless output power here.
Default is "100%".
Table 4-2
-28-
User's Manual of WNRT-320GS
Description
Advertisement
Table of Contents
