I N S T A L L A T I O N; Before You Begin - Motorola DCT 2000 Installation Manual

Section 3

I n s t a l l a t i o n

This section provides instructions for installing and cabling the DCT2000. To complete the
installation, you must:
Connect the cables
Supply power to equipment
Download configuration information and software
Run operational check and diagnostics
B e f o r e Y o u B e g i n
Before you begin, review the installation instructions, gather the required items, and complete
the tasks listed below:
Determine if the subscriber's system requirements include an A/B In, RF Bypass, Dual
A/B-RF Bypass module, or a STARFONE module. These options can be installed before
leaving the office. Installation instructions are provided with these modules.
Verify that you have 75-ohm coaxial cables with F-type connectors and RCA baseband
phono-type cables.
Determine if you are connecting the DCT2000 to a standard TV or a composite (baseband)
monitor.
Place the DCT2000 on a smooth, flat surface and remove any obstructions that could
interfere with the free flow of air over, under, or around it. Advise the subscriber not to
place anything on top of the unit.
I n s t a l l i n g t h e D C T 2 0 0 0
To install the DCT2000:
1
If an add-on module is required and it was not previously installed, do that now. When
installed, verify that the appropriate configuration information has been downloaded via the
access control system.
2
Determine if you are connecting the DCT2000 to a conventional TV or to a monitor. To
install the video connection:
For a conventional TV, use a 75-ohm coaxial cable with F-type connectors.
For a monitor, use an RCA phono cable to connect the
3
Locate the cabling diagram that matches the subscriber's configuration requirement.
4
Connect the cables as illustrated in the diagram.
5
Perform the basic operational check in this section after the DCT2000 is installed.
connector to the monitor.
VIDEO
D C T 2 0 0 0 I n s t a l l a t i o n M a n u a l