Travis Industries 864 TRV GreenSmart Installation Manual page 68

Built-in direct vent fireplace

Hide thumbs Also See for 864 TRV GreenSmart:

Table of Contents

Optional Equipment

Pull the "RECEIVER" connector through the control panel and attach to the receiver (see Figure

27). Then attach the receiver to the control panel with the two #8 machine screws (see Figure

28).

Place batteries into the receiver and transmitter (see Figure 29). Calibrate the receiver to the

transmitter (see Figure 30 - use a paperclip to press the "PRG" button, let it beep, then press any

button on the transmitter – the receiver should beep 5 times – see the operating instructions for

further details).

Place the receiver coverplate (and switch) over the receiver (see Figure 31) and attach with the

two screws included with the receiver (see Figure 32)

(for qualified installers only)

Figure 27

Figure 29

4090227

Figure 28

Figure 30

100-01220_000

Table of Contents

Show Quick Links

Table of Contents

864 trvgreensmart