Lincat OE7013 User And Installation Instructions Manual page 4

HOB DISPLAY SYMBOLS
All symbols are observed on the front control panel.
Power level setting 1 - 9
Residual heat display
Error codes
POWER LEVEL SETTING 1 – 9:
There are 9 power level settings available via the rotary control knob, see pan maximiser note.
RESIDUAL HEAT DISPLAY
When a pan is removed from the hobtop and the temperature of the ceramic glass exceeds 60°C, the
"H" symbol is displayed indicating a hot surface. Refer also to the error codes section.
Whilst the residual heat display is showing, leave the OE7013/7014 Induction hob connected to the
power supply. This allows the internal cooling fans to continue to operate. When the "H" symbol is
extinguished, the mains power supply may be switched off.
ERROR CODES
There are numerous "E" symbol error codes, these identify issues within the induction system and are
primarily of use when reporting a fault to the Service department at Lincat Ltd. Some errors can be
cleared by turning the control to the "off" position, or completely turning off and unplugging the unit,
before switching on again.
PAN DETECTION FUNCTION
Each zone has pan detection; this prevents the coil from turning on without a pan being present. The
coil also turns off as soon as the pan is removed.
A reduction in performance during cooking may be attributed to any of the following:- a blocked air filter,
a confined location with insufficient cooling airflow, or a failed cooling fan. These circumstances will
cause the generator to overheat. Eventually the control electronics will shut down the generator causing
the "H" symbol to display.
REPLACEMENT OF AIR FILTER
Removing and cleaning the air filter will ensure an adequate supply of cool air, and will restore
performance.
Disconnect from the power supply after allowing the Induction hob to cool down. The location of the
filters is shown in the first diagram below. The filters are removed whilst the unit is the correct way up,
but for clarity the unit is shown inverted in the second diagram.
PAN MAXIMISER FEATURE
When a pan is detected on the hobtop, the system optimises the generator for the maximum power for
that pan. The power level settings ( 1 – 9) are a function of the pan maximum power, not the hobtop
maximum power, for example setting 5 (half power) is half the maximum power that the pan can accept,
not half the generator output.
IS430:ECN3559
4