Windows 2003 Enterprise Sp2 Installation - IBM N series Hardware Manual

5. Scroll up to Startup Sequence Options and press Enter. Make sure that the Startup
Sequence Option is configured, as shown in Figure 18-36.
Figure 18-36 Selecting Hard Disk 0 in Startup Sequence Options panel
Phoenix BIOS 4 Release 6
To configure Phoenix BIOS to boot from the Emulex HBA, complete the following steps:
1. Reboot the host.
2. Press F2 to enter BIOS setup.
3. Browse to the Boot tab.
4. The Boot tab lists the boot device order. Ensure that the HBA is configured as the first boot
device. Select Hard Drive.
5. Configure the LUN as the first boot device.

18.2.5 Windows 2003 Enterprise SP2 installation

This section describes installation procedures for Windows 2003 Enterprise SP2.
Copying the SAN boot drivers
When you boot from a LUN, you must ensure that the operating system on the LUN has the
required HBA driver for booting from a LUN. You must download these drivers from the
QLogic or Emulex website.
During the Windows 2003 installation, you must install the driver as a third-party SCSI array
driver from a diskette. To do so, complete the following steps:
1. Download the Emulex or QLogic driver for Windows 2003:
– For Emulex, download the STOR Miniport driver from this website:
http://www.emulex.com/downloads.html
Chapter 18. Boot from SAN
261