IBM N series Hardware Manual page 278

11.Press Esc to return to the previous panel. Press Esc again and you are prompted to save
the configuration settings, as shown in Figure 18-31. Select Save changes and press
Enter.
Figure 18-31 Saving the configuration settings
12.The changes are saved and you are returned to the configuration settings. Press Esc and
you are prompted to reboot the system, as shown in Figure 18-32. Select Reboot system
and press Enter.
Figure 18-32 Exiting the Fast!UTIL
Configuring the PC BIOS boot order
If your host has an internal disk, you must enter BIOS setup to configure the host to boot from
the LUN. You must ensure that the internal disk is not bootable through the BIOS boot order.
The BIOS setup program differs depending on the type of PC BIOS that your host is using.
This section shows example procedures for the following BIOS setup programs:
"IBM BIOS" on page 259
"Phoenix BIOS 4 Release 6" on page 261
258
IBM System Storage N series Hardware Guide