Connecting / Removing - Red Epic Epic-M Operation Manual

CHARGING
CHARGE TIME
A fully discharged REDmote battery will be fully charged in approximately 7 hours.
USING CAMERA
While connected to the camera, the REDmote will automatically recharge its internal battery. Charge
status is indicated by the Green Battery Icon at the top-right of the REDmote LCD display screen. A fully
discharged REDmote battery will be re-charged in approximately 8 hours if connected to a powered
camera. A much faster charge time may be achieved with a USB based power source such as laptop
P.C.
USING USB CONNECTOR
The REDmote can be charged by connecting a Mini-USB-to-USB cable between REDmote and a
computer or a cell phone charger.
NOTE: The REDmote can be charged using the Mini-USB connector while connected and
controlling a camera wirelessly.
1. Connect the USB connector to any computer (computer must be ON to charge REDmote).
2. Connect the Mini-USB end to the REDmote USB Port located on the lower right side (under rubber
protective cover).
3. If the REDmote is powered down (and paired camera is OFF), the REDmote will power UP, display
STARTING UP, display SEARCHING (with flashing Green LED), then settle into IDLE mode.
4. Green battery indicator will blink, indicating REDmote is charging.
5. A fully discharged REDmote battery will be fully charged in approximately 7 hours.

CONNECTING / REMOVING

This section describes how to physically connect / remove the REDmote to / from an EPIC or SCARLET
Brain or to / from the back on an expansion module. On the lower left and right sides of the REDmote
are V-lock release buttons (B, M) that must be depressed to release the REDmote from the camera or
module.
Version 1.6.46
NOVEMBER 17, 2011 ©2011 RED.COM INC.
153