Connect And Format Media - Red Epic Epic-M Operation Manual

Perform a BLACK CALIBRATION of the Sensor.
-
Check your PROJECT SETTINGS (Time Base, Record Resolution, Record Quality, etc.).
-
Frame, focus and record.
-

CONNECT AND FORMAT MEDIA

Identify a REDMAG 1.8" 64GB, 128GB or 256GB SSD that has not previously been recorded to, or is not
a camera master and may therefore be erased and re-used. Aligned the RED logo of the SSD to the
outside, and then push the SSD firmly, but without excessive force, into the slot in the Side SSD Module.
NOTE: When fully inserted, the SSD media protrudes slightly from the SSD slot as indicated above.
When SSD media is inserted into the camera, the camera will recognize if the media is unformatted:
On LCD, EVF and external monitors, in the media section of the GUI, NONE will be displayed twice (as
-
opposed to when no media is inserted, the GUI displays NONE with three dashes below "---").
On REDmote, NONE will be displayed twice (as opposed to when no media is inserted, the GUI
-
displays NONE with three dashes below "---").
On the Side Handle, NA will be displayed (same as if no media is present).
-
To format the media select SECONDARY MENUS > MEDIA FORMAT MEDIA.
When FORMAT is selected, a SLATE dialog box will appear allowing you to add Camera Identity and 3D
Position properties when formatting. When desired options are set, select FORMAT.
Version 1.6.46
NOVEMBER 17, 2011 ©2011 RED.COM INC.
45