Charging Batteries - Red Epic Epic-M Operation Manual

FULL CHARGE
The battery is fully charged when voltage reaches 16.4V (+/- 0.2V) in approximately 90 minutes.
CHARGER TIME-OUT
The charger automatically times-out after 105 minutes if battery does not reach full charge.
OVERCHARGE PROTECTION
Charging will automatically stop if battery voltage reaches higher than 17.0V (+/- 0.12V).

CHARGING BATTERIES

1. Plug the supplied AC power cord into the charger's AC input and then into the AC power source.
2. Verify that the charger's LED status bar is solid Red (indicating ready to receive battery for charging).
3. Insert a REDVOLT battery into the charger. Charger status LED flashes Yellow while charging.
4. Leave the battery to charge for the appropriate time as shown in the table (assuming battery is
discharged completely).
5. The battery is completely charged when the charger status LED turns solid Green.
6. Remove the battery from the charger and repeat operation as necessary for additional batteries.
130 130
Charging REDVOLT using RED TRAVELCHARGER
CHARGE AMOUNT% (MINUTES)
80 (60)
100 (90)
©2011 RED.COM INC.
Version 1.6.46
NOVEMBER 17, 2011