Power Down - Red Epic Epic-M Operation Manual

If a formatted REDMAG 1.8" SSD is attached to the Brain, once powered up the Media Status LED will
illuminate Green. If this LED is not illuminated, verify a formatted REDMAG 1.8" SSD is inserted into the
Side SSD Module and / or format the SSD if it has not previously been formatted on the camera.
NOTE: Once powered up, if the Power Status LED illuminates Red, it indicates low remaining
battery capacity and a battery exchange or switch over to external DC power is recommended.
IMPORTANT: If after upgrading your EPIC to v1.6.20 or higher series firmware, you receive a "New
fan available, please contact RED" notification on the camera, please contact RED technical
support for assistance.
Press OK to use your camera as normal - the message will appear each time the camera is
powered up. Pressing OK, HIDE will hide the message when the camera is powered up, however,
be mindful that until the fan is changed, the camera temperature should be monitored. If the fan is
not replaced as RED recommends and the camera is damaged by overheating, the camera
warranty will be voided.
Once the updated fan has been installed and the camera is powered up, the message will continue
to appear. Press OK, then go to SECONDARY MENUS > SETTINGS > MAINTENANCE >
REDISCOVER and perform the rediscover procedure to clear the message.

POWER DOWN

The camera can be powered down in two ways:
1. Using REDmote or Side Handle Menu controls, or via Touch Screen LCD icons. Refer to SECONDARY
MENUS > POWER.
2. Depress and continue to hold the Power / Record button in its fully depressed position for a minimum
of 5 seconds. When the button is released, INITIATING CAMERA SHUTDOWN will display and camera
will power down.
After Power Down, the Power Status LED will illuminate Red, if an appropriate power source is available.
Version 1.7.10
NOVEMBER 17, 2011 ©2011 RED.COM INC.
33