Setup; Control Panel And Menu Navigation; Setting Stand-Alone, Master/Slave Or Dmx Operation - Martin MAC 350 Entour User Manual

Setup

WARNING! Read "Safety Information" on page 3 before installing, powering, operating or servicing
the MAC 350 Entour.

Control panel and menu navigation

The DMX address and any status messages are shown in the display when the MAC 350 Entour is powered
on.
A
The control panel is used to set the MAC 350 Entour to DMX or stand-alone (single fixture or synchronized
master/slave) operation, set its DMX address, configure individual fixture settings (personality), read out
data, and execute service utilities.
See "Control menu" starting on page 37 for a complete list of the menus and commands available in the
control panel.
See Figure 4. To enter a menu, press [Menu]. Press the [Up] and [Down] arrows to scroll within a menu. To
select a function or submenu, press [Enter]. To escape a function or move back one level in the menu
structure, press [Menu].
Note: [Enter] must be pressed and held for a few seconds to enter the Service menu (SERV).

Setting stand-alone, master/slave or DMX operation

DMX control, stand-alone and synchronized master/slave modes are selected as follows:
• To set the MAC 350 Entour to stand-alone operation, press [Up] or [Down] until SA is displayed, then
select RUN, then ENA.
• To set the MAC 350 Entour to synchronized stand-alone operation, in which a master fixture sends
synchronizing signals to slave fixtures, select SA→SAE then MAS for the master fixture, SLA for slave
fixtures, or SIN to return to single fixture operation.
• To disable stand-alone operation and return the MAC 350 Entour to DMX control, select
SA→RUN→DIS.
The MAC 350 Entour is supplied configured for DMX control by default.
14
B C
Figure 4: Control panel and display
MAC 350 Entour user manual
A – Four-character LED display
B – Service indicator LED
C – DMX input indicator LED
D – UP button
E – ENTER button
D
F – DOWN button
E
G – MENU button
F
G