Martin MAC 350 Entour User Manual page 4

• Do not expose the fixture to rain or moisture. Use in a dry location only.
• Refer any service operation not described in this manual to a qualified technician.
P R O T E C T I O N F R O M B U R N S A N D F I R E
• Do not operate the fixture if the ambient temperature (Ta) exceeds 40° C (104° F).
• The exterior of the fixture becomes hot during use. Avoid contact by persons and materials. Allow the
fixture to cool for at least 20 minutes before handling.
• Keep all combustible materials (e.g. fabric, wood, paper) at least 200 mm (8 ins.) away from the head.
• Keep flammable materials well away from the fixture.
• Ensure that there is free and unobstructed airflow around the fixture, including the heatsinks in the yoke
and base.
• Do not illuminate surfaces within 500 mm (20 ins.) of the fixture.
• Do not attempt to bypass thermostatic switches or fuses. Replace defective fuses with ones of the
specified type and rating.
• Do not stick filters, masks or other materials onto any lens or other optical component.
• Do not modify the fixture in any way not described in this manual
• Install only genuine Martin parts.
P R O T E C T I O N F R O M I N J U R Y
• Do not look at LEDs from a distance of less than 8.7 meters (28 ft. 7 ins.) from the front surface of the
fixture without protective eyewear such as shade 4-5 welding goggles. At less than this distance, the LED
emission can cause eye injury or irritation. At distances of 8.7 meters (28 ft. 7 ins.) and above, light output
is harmless to the naked eye provided that the eye's natural aversion response is not overcome.
• Do not look at LEDs with magnifiers, telescopes, binoculars or similar optical instruments that may
concentrate the light output.
• Ensure that persons are not looking at the LEDs from within 8.7 meters (28 ft. 7 ins.) when the product
lights up suddenly. This can happen when power is applied, when the product receives a DMX signal,
when stand-alone operation starts or when service menu items are selected in the SERV menu.
• To minimize the risk of eye irritation or injury, disconnect the fixture from power at all times when the
fixture is not in use, and provide well-lit conditions to reduce the pupil diameter of anyone working on or
near the fixture.
• Install as described in this manual a secondary attachment such as a safety cable that is approved by an
official body such as TÜV as a safety attachment for the weight of the fixture. The safety cable must
comply with EN 60598-2-17 Section 17.6.6 and be capable of bearing a static suspended load ten times
the weight of the fixture.
• If suspending from a rigging structure, attach the fixture with two evenly spaced clamps. Do not use only
one clamp.
• Ensure that any supporting structure and/or hardware used can hold at least 10 times the weight of all the
devices they support.
• Allow enough clearance around the head to ensure that it cannot collide with an object or another fixture
when it moves.
• Check that all external covers and rigging hardware are securely fastened.
• Block access below the work area and work from a stable platform whenever installing, servicing or
moving the fixture.
• Do not operate the fixture with missing or damaged covers, shields or any optical component.