Inside Corners - Bernina Serger User Manual

Firm fabric, 6" x 6"
Fabric:
80/12 Universal
Needle:
3 cones of serger thread (blue, red, green)
Thread:
Standard
Presser Foot:
3-thread overlock
Stitch:
Using the small screwdriver and brush/needle insertion tool, remove
the left needle. Snug the needle set screw after removing the needle.
Thread the serger for a narrow 3-thread overlock stitch using thread
colors to match the color-coded threading path on the serger. Adjust
all thread tension settings for a balanced stitch as indicated below.
Inside Corner
This technique works well for continuous plackets on sleeves and
back neck openings.
• Cut an inside corner into the fabric.
• Snip into the corner ¼" (the width of the stitching).
• Serge until the knife reaches the end of the cut.
• Use the handwheel to lower the needle into the fabric.
• Lift the presser foot and straighten the corner towards you.
• Lower the presser foot; continue serging.
.
Inside Corner
Suggested Settings
Upper Looper ····························· 3-5
Lower Looper ····························· 3-5
Left Needle ······························· N/A
Right Needle ····························· 3-5
Stitch Length ······························ 2.5
Cutting Width ····························· 2-3
Differential Feed ························ N
17