Track - BOMBARDIER 1983 Shop Manual

c
TRACK TYPE APPLICATION
Refer to the "Technical Data" section (09-05),
INSPECTION
Visually inspect track for cuts and abnormal wear. Inspect
track for broken rods. If excessive damage is ejDent and
rods are broken, replace track. Inspect track for dmnaged
or missing inserts. Replace damaged insert(s).
+
WARNING: Do not operate a snowmobile with a
cut, torn or damaged track.
REMOVAL
Elan, Spirit
Remove the following items:
- Tool box
- Chaincase access plug
- Drive axle cotter pin and washer
- Suspension
- Rear axle
- The two drive axle seals
- End bearing housing
- Drive axle
- Track
Citation, Mirage, Nordik, Skandic
Remove the following items:
- Pulley guard and drive belt
- Air silencer
- Injection oil reservoir (if so equipped)
- Battery and battery support (if so equipped)
- Speedometer, angle drive (if so equipped)
- Chaincase cover, sprockets and chain
- Suspension
- Countershaft bearing housing (clamp)
- Drive axle shaft bearing housing (left side)
- Drive axle (outwards from left side)
- Upper center idler(s) assembly
- Track
SECTION 05 SUSPENSION
SUB-SECTION 05 (TRACK)
TRACK
Everest, Blizzard, Blizzard MX
Remove the following items:
- Speedometer cable and protector (if so equipped)
- Chaincase cover, sprockets and chain
- Suspension
- Two drive axle seals
- Chaincase
- Drive axle (outwards from chaincase side)
- Upper center idler wheel (if applicable)
- Track
Alpine
Remove the following items:
- Release the chain tensioner of the transmission chain
- Bogie wheels
- Rear axle(s) assembly(ies) .
- Drain the transmission oil
- Drive axle seal(s)
- End bearing(s) housing
- Drive axle(s) (outwards from end bearing(s) housing)
- Track(s).
PAGE 289