2/19/04
Line Block Drawing & Box Drawing Shading
"S" 1 = Black
3.3.
Bar Code Scaling (Width only)
n = "mnnn" or "Mnnn"
This parameter specifies the bar code width scaling.
(100%).
3.4.
Bar Code Human Readable Line On or Off
n = "r0" or "R0"
n = "r1" or "R1"
Default:
Default:
This parameter specifies whether or not the printer prints the human readable line below the bar code.
readable characters are always printed with OCR-B font at 10 cpi pitch
enhancements are masked.
3.5.
Quiet Zone
n =
"onnn" or "Onnn" (nnn = 0 ~ 32767)
Quiet Zone is the space on both side of the bar codes.
by the "u" or "U" parameter.
default setting of Quiet Zone width is 1 inch.
3.6.
Bar Code, Expanded Character Unit, Line Block Drawing & Box Drawing
Units
n = "u0" or "U0"
n = "u1" or "U1"
n = "u2" or "U2"
n = "u3" or "U3"
n = "u4" or "U4"
n = "u5" or "U5"
n = "u6" or "U6"
n = "u7" or "U7"
This parameter specifies the measurement units of X-axis offset, Y-axis offset and bar code height.
2 = Vertical stripes
3 = Horizontal stripes
4 = Cross hatch
(nnn = 0 ~ 32767)
Human readable line OFF
Human readable line ON
Human readable line ON when the following barcode types are selected.
(1)
"T5" or "t5"
(2)
"T6" or "t6"
(3)
"T130" or "t130"
(4)
"T131" or "t131"
Human readable line OFF
All others
Note that the default setting is subject to the bar code mode selected by "t" or "T".
( For the description of "u" or "U" parameter,
Millimeters (default)
1/10"
1/100"
1/12"
1/120"
1/10 Millimeter
1/300"
1/720"
CHAPTER 8 BAR CODE CONTROL - 6
The unit of "nnn" is %.
The default value is m100
and all the current character style
Its width can be specified using the units which are set
see the next section.)
Human
The