Pjl Reset Conditions; Remember These Points About Environments - Brother HL-1050 Technical Reference Manual

2/19/04
The diagram below illustrates how the environments interact and how the modified print environment is
affected.
FACTORY DEFAULT ENVIRONMENT

6.1.2. PJL reset conditions

The result of PJL reset condition is different from that of a printer language reset (for example, ESC E).
Printer language reset loads the PJL Current Environment values into the Modified Print Environment. PJL
reset conditions load the User Default values into the PJL Current Environment, which are then loaded into
the Modified Print Environment.
PJL reset occurs on the following events.
1.
2.
3.
4.
5.
6.
7.
8.
9.

6.1.3. Remember these points about environments

Remember the following points when you use PJL to set the printer to a desired state.
1. The current feature settings are the same as the control panel values ( or values in the remote printer
console program) when beginning a PJL job.
2. The current feature settings (Modified Print Environment) become the same as the PJL Current
Environment when the printer enters a printer language. The feature settings are modified by the printer
language command once a printer language is started. All other settings are overridden by printer
language commands.
3. The SET command changes the PJL Current Environment settings. These settings are effective until the
next PJL reset condition.
4. Control Panel settings, the remote printer console program settings or the DEFAULT command changes
the User Default Environment.
5. Printer language commands change the Modified Print Environment. These settings are effective during a
printer language job. The PJL Current Environment settings are loaded into the Modified Print
Environment by a printer language specific reset, for example, ESC E for PCL.
@PJL INITIALIZE
USER DEFAULT ENVIRONMENT
@PJL RESET
PJL CURRENT ENVIRONMENT
LANGUAGE RESET, @PJL ENTER, OR ANY LANGUAGE SWITCH
MODIFIED PRINT ENVIRONMENT
Power on
UEL command (when not between a JOB and EOJ command pair)
@ PJL INITIALIZE command
@ PJL RESET command
@ PJL JOB or EOJ command
Other printer-specific events
Reset from Control Panel
Language specific exit command
Emulation switching command
CHAPTER 5 PJL - 16
CONTROL PANEL
OR @PJL DEFAULT
@PJL SET