Summit Client; Certs; Wireless Zero Config Utility And The Summit Client - LXE MX7 Reference Manual

Start Menu Program Options

Summit Client

Access:
Summit automatically installs and runs after every cold and warm boot.
Disable Summit
Tap the Disable Radio button. The radio is enabled by default after every cold reset.
Enable Summit
When the radio is disabled, tap the Enable Radio button. The radio is enabled by default after
every cold reset.
See Chapter 5 "Wireless Network Configuration" for Summit Client Utility setup information and
instruction.

Certs

Access:
Contents of README.TXT file located in Start | Programs | Summit | Certs menu option:
CA Certificate files, user certificate files and PAC files are accessed only from this
location. When entering the certificate filenames in the Summit Client Utility (SCU),
only the filename and extension are entered. Only PEM, DER and PFX extensions are
allowed for certificate files.
See Chapter 5 "Wireless Network Configuration" for directions for acquiring CA and user
certificate files.
Wireless Zero Config Utility and the Summit
Client
This utility has an icon in the toolbar that looks like networked computers with a red X through
them, indicating the application is enabled and the MX7 is not connected to a network.
If you will be using the Wireless Zero Config Utility to configure the radio, or connect to a
network, perform the following steps:
1. Tap the Summit Client Utility icon on the desktop, or tap Start | Programs | Summit |
SCU.
2. Select ThirdPartyConfig in the Active Config drop down box.
3. A message appears that a Power Cycle is required to make settings activate properly. Tap
OK to close the message window.
4. Tap the Power button to place the MX7 in Suspend, then tap the Power button to wake
the MX7 from Suspend mode.
The Wireless Zero Config utility begins.
E-EQ-MX7RG-B
| Programs | Summit
Start | Programs | Summit | SCU
Start | Programs | Summit | SCU | Enable Radio
| Programs | Summit | Certs
83
MX7 Reference Guide