Using The Adjustment Feet - Runco Reflection CL-410 Owner's Operating Manual

Connection and Setup
Using the Adjustment
Feet
The height of the projector can be adjusted using the adjustment feet. This is useful for
correcting the angle of the projection when the projector is placed on an uneven surface
or when the screen is slanted. The adjustment feet are connected to threaded bolts, which
can be turned in to shorten or out to lengthen.
1 Lift the side of the projector you would like ti raise
or lower.
2 Turn the adjustment feet to shorten or lengthen. If
the screen is at an angle, the adjustment feet can
be set higher than the rear adjustment feet to set
the image at an angle.
3 Return the projector to the original
position.
Note:
• When lowering the projector, be careful not to get your finger caught in the
area between the adjustment foot and the projector.
• The projector is adjustable up to approximately 5 degrees from the standard
position.
• When the height of the projector is adjusted, the image may become distorted
(keystone distortion). See "Keystone" on page 44 for details on keystone
correction.
18
���������������