Problems With Your Wine Cooler; Troubleshooting - Vinotemp VT-21TS-2Z Owner's Manual

PROBLEMS WITH YOUR WINE COOLER

Most common problems can be solved easily, saving you the cost of a possible service call.
Try the suggestions below to see if you can solve the problem before contacting Vinotemp at
info@vinotemp.com.
PROBLEM
Wine cooler does not
operate
Wine cooler is not cold
enough
Wine cooler makes too
much noise
Internal light is flashing
Wine cooler has started to
frost
Door will not close properly
Light does not work
Temperature LED display
is blank
Temperature LED display
error
Buttons are not functional
10

TROUBLESHOOTING

POSSIBLE CAUSE
Ensure cooler is plugged in to electrical outlet
Check voltage level
Check for broken fuse
Ensure temperature control is at a proper setting
Ensure wine cooler is away from heat sources or direct
sunshine
Check for proper clearance on all sides of the wine cooler
Ensure door is properly closed and not open too frequently
Ensure cooler is level and on steady surface
Check for proper ventilation and clearance
Check to make sure cooler fans are operating correctly
Check that selected temperature is not higher than internal
cabinet temperature
Automatic defrost function has started. This is a normal
function
Excess humidity or very low temperatures may cause frost
to build. Unplug the cooler and allow it to defrost, or defrost
by hand
The wine cooler is not level
The doors were not properly installed
The seal is weak
The shelves are out of position
Call the service center
Main control board does not work
The Power Control Board is not functioning
There is some problem with the plug (no power supply)
Display has suffered too much wear and tear
Temperature sensor has been cut off
Temperature controller panel is damaged
W W W . V I N O T E M P . C O M
1
0