Table of Contents
Advertisement
INSTALLING THE STAINLESS STEEL HANDLE
This wine cellar includes a stainless steel handle that is not required to operate this unit. To install the handle
please follow the below instructions:
Pull away the door gasket in the area where
•
the handle is to be installed - you can see two
designated holes for handle installation. The
gasket is easily displaced by hand, no tools
are necessary.
Install the handle tightly as shown below with
•
the two screws, lock washers and flat washers
provided. (DO NOT over tighten as this will
cause damage to the handle assembly and
stainless steel surface of glass door).
Replace the door gasket to its original position.
•
O PERATING YOUR WINE COOLER
The wine cooler should be placed in a position where the ambient temperature is between 5-38°C/41- 100 °F.
Humidity level is between 45 - 90%. If the position is above or below this range, the performance of the
unit may be affected. For example, placing your unit in extreme cold or hot conditions may cause interior
temperature to fluctuate.
NOTE:
l
When you use the wine cooler for the first time or restart the wine cooler after having been
shut off for a long time, there could be a few degrees variance between the temperature you select and the
one indicated on the LED readout. This is normal and it is due to the length of the activation time. Once the
beverage cooler is running for a few hours everything will be back to normal.
l
If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before restarting the unit.
If you attempt to restart before this time delay, the cooler will not start.
11
Advertisement
Table of Contents
