Password For Isdn Dial-In; Irreversibly Deactivating The Microphone; Starting The Camera Using The Factory Ip Address; Resetting The Camera To Factory Defaults - Mobotix M12 User Manual

M12 Camera Manual Part 1

1.8.3 Password for ISDN Dial-In

Dialing into the camera via ISDN is protected by a separate password. When set-
ting up a dial-in connection from a computer, you need to provide this information:
linux
• User name is
• Password is tux
Enter the user name and password exactly as shown above. Note that both entries
are case-sensitive.

1.8.4 Irreversibly Deactivating the Microphone

Deactivating a camera's microphone may become necessary in order to protect
the privacy of people at a workplace or for other reasons. You can permanently
and irreversibly deactivate the microphone in the Admin Menu > Loudspeaker
and Microphone dialog.
CAUTION: This deactivation is permanent and cannot be reversed
even by MOBOTIX engineers. Deactivating the microphone will
also deactivate all features that use the camera's microphone.

1.8.5 Starting the Camera Using the Factory IP Address

If the camera's IP address is not known any more, you can start the camera with its
factory IP address. Section 3.6, Starting the Camera Using the Factory IP Address ,
describes this procedure in more detail.

1.8.6 Resetting the Camera to Factory Defaults

All settings of the MOBOTIX camera can be reset to the factory default settings. This
makes sense if you have, for example, obtained a camera without any information
or you would like to reset all settings after testing the camera. In order to perform
this procedure, you need to have access to the administration area of the camera
(admins group). Open Admin Menu > Reset ... to reset the camera to factory de-
faults.
Note: In contrast to the method described in section 3.6, Starting the Camera
Using the Factory IP Address ,
when resetting the camera to factory defaults. Likewise, the
word will be reset.

1.8.7 Activating Event Control for Security Applications

In its default configuration, the camera's event control and video motion detection
features are not enabled. In order to activate event control as a whole, open Se-
tup Menu > General Event Settings and activate the Arming switch or click on the
Arm & Record softbutton of the browser interface. The video motion detection
window is visible again (dotted frame in the center of the live image) and the ca-
mera stores images as soon as the video motion window detects movements.
© MOBOTIX AG • Security-Vision-Systems • Made in Germany
www.mobotix.com • sales@mobotix.com
all users will be deleted
(except the admin user)
admin user's pass-
21
/92
ISDN Dial-in
User: linux
Password: tux
The microphone can be
irreversibly deactivated!
The configuration can also
be reset partially
If the dotted rectangle in
the live image is visible,
the camera is armed