Table of Contents
Advertisement
MCU status line
On:
The MultiSite/MCU/DuoVideo indicators will be displayed and provide information about the conference.
Off:
The MultiSite/MCU/DuoVideo indicators will not be displayed.
Auto:
The MultiSite/MCU/DuoVideo indicators will be displayed for a few seconds and then timed out. When
grabbing the remote control, the indicators will be shown again.
System Name
Identifies the system:
• during an MCU conference call.
• when using the Web-interface.
• when the codec is acting as an SNMP Agent.
• towards a DHCP server.
• as an H323 ID.
Menu Password
Enter the code whch should be entered to get access to the menus on the TANDBERG system. When pressing
the 'Menu' button on the remote control, the user will be asked to enter the Password written here.
Camera Brightness
To manually adjust the brightness select 'Manual' and use the arrow keys to adjust.
Monitor Brightness
To manually adjust the brightness select 'Manual' and use the arrow keys to adjust.
Whitebalance
To manually adjust the whitebalance select 'Manual' and use the arrow keys to adjust.
Web Snapshots
The system is able to generate JPEG snapshots and provide them to the world outside by request (as 'http get' or
via ftp). See Appendix 5 for descriptions of the possible snapshot files.
On:
Snapshots generation is enabled.
Off:
Snapshots generation is disabled.
S
NOTE
NAPSHOTS ARE NOT GENERATED IF THE CONFERENCE IS SECURE
TANDBERG Videoconferencing System
.
37
Advanced use
Advertisement
Table of Contents
