KitchenAid KAR-13 Technical Education page 20

20. Lift the rear of the evaporator and the front
of the ice making component housing,
then slide the housing under the evapora-
tor toward the front of the unit until the
housing clears the evaporator.
Evaporator
Ice Making Component Housing
21. Rotate the ice making component housing
so you can easily access the recirculation
pump mounting screws.
Rotate Housing Over Evaporator
Water Recirculation Pump
22. Use a 9/32" socket or a phillips screw-
driver, and remove the recirculation pump
mounting screws.
23. Disconnect the end of the water inlet fill
tube from the recirculation pump and re-
move the pump.
Water Inlet Fill Tube
4-6
3 Pump Screws