Adjusting Harness Strap Height & Headrest - Britax Safe-n-Sound 7200/A/2010 Series Instructions For Installation And Use Manual

HOW TO INSTALL
ADJUSTING HARNESS STRAP HEIGHT & HEADREST:
FOR BABY USE REARWARD-FACING
Correct fitment of the harness is very important as it restrains the baby in the restraint. The headrest
must be in the correct position and the harness must fit firmly around upper torso of the baby and be
positioned so as to leave the baby's arms and legs free.
For babies in rear facing mode the headrest must be in the position where the top of the shoulder strap
slots are nearest to the child's shoulders, but not lower than the child's shoulders. Instructions for
adjusting the headrest is on the next page. If your baby has reached the lower shoulder height marker
then the restraint should be converted for "child use" (Refer to Forward Facing section starting on
page 29).
Lower shoulder
height marker.
22
Harness Shoulder slots.
Harness tongues and buckle.
Lap strap slots.
Crotch strap slots.
Adjuster button.
Harness adjuster strap.
1. The shoulder straps must be in the slots which are nearest to the child's shoulders, but not lower
than the child's shoulders. There is only one set of slots so the seat will always have the shoulder
straps in place.
2. Use the Infant Safety Cushion Insert when rear facing for smaller babies until their shoulders reach
the Lower Shoulder Height Marker. Remove the Infant Safety Cushion for longer use whilst still in rear
facing.
3. Discontinue the use of the Infant Safety Cushion Insert if there is insufficient room for the baby or
shoulders reach the Lower Shoulder Height Marker.
REARWARD-FACING BELT PATH;
HOW TO INSTALL
shown as blue.
23