Britax Safe-n-Sound 7200/A/2010 Series Instructions For Installation And Use Manual page 20

HOW TO INSTALL
ADJUSTING HARNESS
STRAP HEIGHT AND
HEADREST: FOR CHILD USE
FORWARD-FACING
Correct fitment of the harness is very
important as it restrains the child in the
restraint. The harness must fit firmly
around the upper torso of the child and
be positioned so as to leave the child's
arms and legs free.
The headrest must be in the position
where the top of the shoulder slots are
nearest to the child's shoulders, but
not more than 25mm below the child's
shoulders. If the headrest is in the top
position and the shoulders are above the
upper shoulder height marker then the
child is too tall for the restraint and the
restraint should not be used; move to
next type of restraint (see pages 8 and 9).
The shoulder straps must be in the slots which are nearest to the child's shoulders, but not more than
25mm below the child's shoulders.
Note: This child restraint does not require the strap to be disconnected to adjust their height, only the
headrest needs to be moved to adjust the shoulder strap position.
38
Harness Shoulder slots.
Upper shoulder
(Height marker
hidden when
Harness
the headrest
tongues
is not at full
height)
Lap strap slots
Lower
shoulder
height
Harness buckle
marker
Crotch
strap flap
Adjuster
button
Harness adjuster strap
ADJUSTING AHR TILT & ADJUST
HEADREST AND HARNESS STRAP
HEIGHT
A. Loosen the harness straps before adjusting the
headrest.
B. You do not need to remove the restraint from the
vehicle to adjust the harness or headrest positions.
Small adjustments maybe done with the child the
seat, the child will need to lean forward to allow the
headrest to be pulled forward.
C. To adjust the headrest, gently pull the top of
the headrest forward and then pull up or push
down so that the shoulder strap slots are level
with or slightly above your child's shoulders. If
the headrest is just above the shoulders then the
harness level will be correct.
NOTE: For comfort ensure the bottom edges of the
headrest are not contacting the child's shoulders.
D. Release headrest so that it moves back and
locks into position. Ensure that it has locked in
position by gently pushing down on it.
E. Ensure there are no twists in the harness strap
and the buckle tongues face the correct way.
F. If the headrest is moved up, then down with
the child in the seat, before use, check that the
headrest cover has not bunched up behind child's
back.
HOW TO INSTALL
Tilt headrest
forward to unlock
C
While holding the
headrest forward,
pull up or down to
desired position.
C
Rotate back to lock headrest.
39