Child Seat Functions; Click & Safe ® Snug Harness Indicator; Adjusting The Harness Height; Adjusting The Harness Length - Britax ADVOCATE CLICKTIGHT User Manual

Britax Child Safety, Inc.

Child Seat Functions

Click & Safe Snug Harness Indicator
®
IMPORTANT: See pages 20-21 for detailed instructions
on securing your child.
The Click & Safe is designed to sense tension when the
adjuster strap is pulled and will provide an audible indication
when the child seat harness is within range of appropriate
snugness. The harness should have a comfortable but snug
fit around the child. A snug strap should not allow any slack.
It lies in a relatively straight line without sagging. It does not
press on the child's flesh or push the child's body into an
unnatural position. You should not be able to pinch excess
webbing at the shoulder. Follow the steps below to tighten
the harness.
To tighten the harness:
1. Remove any bulky clothing
from your child before
tightening the harness.
2. Check for proper harness
height.
3. Pull any excess slack in
the harness up to the
child's shoulder area.
4. Pull the harness adjuster strap straight out from the
child seat until a click is heard. The Click & Safe
indicator will click when the harness is within range
of appropriate snugness�
NOTE: If there is still slack in the harness, repeat the
steps above until another click indicates a snug harness.
It may be necessary to double check that the harness is
within range of appropriate snugness. Always confirm
a snug fit by attempting to pinch excess webbing in the
shoulders.
9 Check that the harness is buckled and secure.
9 Check that the harness is snug and you can not pinch
excess webbing at the shoulder.
22
ADVOCATE/BOULEVARD CLICKTIGHT User Guide

Adjusting the Harness Height

• In rear-facing mode, the harness straps should be in
the closest position at or below your child's shoulders.
See page 7.
• In forward-facing mode, the harness straps should
be in the closest position at or above your child's
shoulders. See page 7.
1. Loosen the harness.
a. Push harness
release button.
b. Pull both harness
straps forward.
2. Squeeze the harness
height adjuster, slide the
harness into the desired
position and release.
3. Ensure the harness has
locked into position.

Adjusting the Harness Length

IMPORTANT: Adjust the harness to the shortened length
if a snug harness cannot be achieved with a small infant
(approx. 10 lbs and under).
Shortening the Harness
1. Open the CLICKTIGHT.
a. Press the dimple on
the CLICKTIGHT
dial.
b. Rotate dial clockwise
until CLICKTIGHT
releases and lift to
open.
2. Disconnect the end of
one harness from the
anchor.
1b
1a
1a
1b
23