Britax Safe-n-Sound 7200/A/2010 Series Instructions For Installation And Use Manual page 9

HOW TO SETUP
F. Engage seat belt buckle & tongue and tighten the
seat belt allowing the sash to fully retract. Use the
rear facing seat belt lock-offs to prevent the seat
belt loosening. See illustrations on the next page.
Do not use the lock-off if the buckle interferes with
closing the lock-off.
Note: Seat belt buckle and tongue must not rest
between restraint cover and restraint. If seat belt
buckle is adjustable, adjust buckle as low as
possible away from the restraint.
G. Replace the centre panel properly, ensure the
harness buckle is through the panel, and reconnect
the hook and loop to retain the cover. Then place
back the headrest trim end along the backrest. For
smaller babies replace the Infant Safety Cushion
Insert. Do not use the Infant Safety Cushion if
the child's shoulders reach the Lower Shoulder
Height Marker. See page 23 and 24 for advice on
positioning the shoulder straps and the headrest.
NOTE: Seat belt extenders should not be used if
the seat belt is not long enough to secure the child
restraint. If they are used then the buckle must not
enter the seating zone.
16
Pass buckle tongue through here
G
H. Align restraint centrally to the chosen
seating position. Pull sash portion of
seat belt until all slack is removed from
Lap portion of seat belt so as to hold the
restraint firmly against the vehicle seat
back. For retractor seat belts. Allow excess
belt to feed back into retractor. Lock the
rear facing seat belt lock-off to prevent the
seat belt slackening.
On the opposite side to the
seat belt buckle, only pass
the lap portion of the belt
through the lock-off and
lock in place (optional).
If placing the restraint in a seating position
with a lap only seat belt, tighten the
seatbelt so as to hold the restraint firmly
against the vehicle seat back.
HOW TO SETUP
Rear facing
seat belt
lock-off
H
On the car seat belt buckle side, pass both lap and
sash seat belt through the lock-off and lock in place.
17