Data Port - TANDBERG 8000 MXP User Manual

6.1.4

Data port

The data port(s) are implemented as Data Communications Equipment (DCE). The connector
used is female 9-pin D-subs.
NOTE! Data port 2 is used by both Wave II Camera and Precision HD Camera and has different
pin-out scheme for the different use.
The TANDBERG main camera is normally connected to data port 2 and pin number 4 provides
12V DC / 1 Amps to the main camera. Otherwise the pin-outs for both data ports are the same.
Signal name
Carrier detect, CD
Receive data, RXD
Transmit data, TXD
Data terminal ready, DTR
Signal ground, GND
Data set ready, DSR
Ready to send, RTS
Clear to send, CTS
Ring indicator, RI
Data Port 2 with Precision HD Camera
Pin-outs for the THSI (TANDBERG High Speed Interface) on data port 2:
Signal name
Video LVDS +
Receive data, RXD
Transmit data, TXD
Power, +12V
Signal ground, GND
Video LVDS -
NOTE! The enclosed TANDBERG Camera Cables must be used! Do not use other camera
cables as this might cause problems with the transfer of video signals from the Precision HD
Camera.
Direction Pin number
From DCE
From DCE
To DCE
From DCE
From DCE
To DCE
From DCE
From DCE
Direction Pin number
To DCE
From DCE
To DCE
To DCE
Peripheral Equipment
1
2
3
4
5
6
7
8
9
1
2
3
4
5
6
237