TANDBERG 8000 MXP User Manual page 247

TANDBERG 8000 MXP
3 Audio Outputs:
1 output (line level) via RCA connector providing audio from far end, in addition to dial
tones. This output also supports S/PDIF. S/PDIF (Sony/Philips Digital Interface) is used
by the Digital Natural Audio module.
1 AUX output (line level) via RCA connector providing a mixed signal between audio from
the local side (except from the AUX input) and audio from the far end. This output is
intended for connection to a telephone add-on system. When system is configured as
stereo, this output will provide the left stereo information.
1 VCR output (line level) via RCA connector providing a mixed signal between audio from
the local side (except from the VCR input) and audio from the far end. This output is
intended for connection to a VCR. When system is configured as stereo, this output will
provide the right stereo information.
Audio output connector specification:
Connector label
Signal type
Connector (codec)
Output impedance
Max output level when set to maximum output level
and volume control set to max.
Max output level when set to minimum output level and
volume control set to max.
Range, menu adjustable output gain
Volume control attenuation (audio out 1)
* Additional attenuation is possible on room/loudspeaker audio output using the volume control
setting
234
Audio outputs
Unbalanced
Female RCA/phono, sleeve-ground,
centre-signal
680 ohms
15.5 Vpp
1.2 Vpp
22.5 dB (16 steps of 1.5 dB)*
0 to 21 dB + mute (steps of 1.5 dB)