Section Iii: Pre-Fab Insert Installation - New Buck Corporation 74 User Manual

PRE-FAB INSERT INSTALLATION
The Model 74 has been tested with the following UL listed manufactured Pre-Fab Fireplaces:
Heatilator Security
Tempco Preway
Marco FMI
Woodside Majestic
The Model 74 will fit any of models that are large enough to accept them.
NOTE: A full chimney liner is required in a Zero Clearance or pre-fab fireplace.
NOTE: The ash lip, smoke baffle and smoke shelf may be removed if necessary to provide
room for these models. Any other alteration to unit will void ALL New Buck Corporation
responsibility and liability. The warning label below supplied with stove must be attached to
the back of fire -place.
Except for "NOTES" above, please follow
including Minimum Clearances for stove and floor protector in Section II.
WARNING:
restored to its original condition for safe use, if
the fireplace insert is removed.
SECTION III
instructions for Masonry Insert Installation
This fireplace must be
Page 10